Print this article Font size 16
The heater motor plays an important role in ensuring the normal functioning of your car's heating system. Therefore, if the motor fails, it needs to be replaced.
Appearance of the device
Work on replacing the stove motor can be divided into two main stages:
- Preparation;
- Replacement.
About each stage in more detail.
Minor improvements
In winter, motorists often have to drive with the heater on. Otherwise, it will be quite cold in the cabin, and the windows tend to fog up. At the same time, many car enthusiasts may be annoyed by the rattling sound when the stove is running, which is especially audible at the maximum operating mode of the stove. The problem here is in the lower panel of the heater housing. It is attached on peculiar hooks. On the one hand, this simplifies dismantling if necessary; on the other hand, these fasteners can be easily unfastened. After this, the panel begins to vibrate, causing unpleasant sounds.
To fix it, simply fasten the hooks in place. Sometimes they just break off. In this case, the only option is to replace the stove assembly.
If the stove does not heat well, then it makes sense to check how the radiator is warming up. It is necessary to remove the deflector; this is done using a slotted screwdriver. After that, start the engine and let it warm up. During this time, the radiator should heat up quite well. If this does not happen, then check the functionality of the heater valve. The reason may also be a clog in the radiator itself. It must be removed and washed. For this, it’s a good idea to use a strong solution of citric acid.
If you have a car produced before 2006, then it makes sense to install a pre-heater on it. This will allow you to quickly warm up the interior in winter. There will be no problems with installation, you will just need to purchase a heater designed for the injection “ten”.
Conclusion
. The heater fan in domestic cars is not very reliable. This is why you can so often hear the question of how to replace the stove fan on a VAZ 2110 and 2112. In fact, the work is not difficult, but due to the large number of small parts that need to be removed, the replacement can take several hours. At the same time, you should be quite careful due to the abundance of plastic parts.
How to remove and replace the heater motor on VAZ-2110, 2111 and 2112
Hi all. Today we will tell you how to get to the VAZ-2110 heater motor and remove it for repair or replacement. The procedure is relatively simple, you don’t have to disassemble the heater itself and this is a big plus, because disassembling it is really not as easy as it seems. So, let's start by following the instructions and removing the windshield trim and trim, the right soundproofing padding and the windshield wiper itself.
First of all, disconnect the battery. Then disconnect the positive connector of the heater motor:
Then, having gained access, unscrew the nut securing the heater motor mass:
We take a strong flat screwdriver and carefully unclip the latches of the stove body, be careful, they are springy, do not lose sight of them
