Renault Fluence relay box and fuses: where are they located?

The French car Renault Fluence was released in 2009. However, many years have passed since that time and the car has undergone various modifications. Along with the restyling of the model, the exterior of the interior also changed.

But this did not in any way affect the location of the car's fuses and relays.

The electrical equipment of this car is made at a high professional level. Electronic systems work properly, and in the event of a failure, the driver is immediately notified of the occurrence of a breakdown.

Reliable protection against increased current in the system is provided by special inserts - fuses installed in the mounting block. If a short circuit occurs, the insert will burn out and be replaced with a new one.

Advice. There is a category of car enthusiasts who temporarily install a “bug” in the form of a wire instead of a fuse. This is not recommended, as there is a risk of failure of the entire mounting block. Experienced drivers always have one more block in stock for replacement. At the same time, it must be designed for the same current strength so that the electronics do not break.

Renault Fluence fuse diagram

Below is a diagram of each mounting block separately and it is explained which circuits the elements are responsible for.

Main module of the engine compartment.

NumberDecoding
1Right side light, license plate light, cigarette lighter, navigator, tidy switches, power window keys.
2Right side of the dimensions, left side of the trunk light
3Headlight washer pump
4PTF
5/6Headlights in high beam mode for the left and right sides, respectively.
7Diagnostic connector, headlight range control, automatic handbrake, window dimmer.
8ABS and ESP control module
9Front wiper
10Airbag control system.
11Not applicable
12/15Automatic transmission control unit,/module power line
13ECM module
14Oxygen concentration sensor heater.
16Brake lights, electric power steering
17Headlight range control, reversing lighting, gearbox sensors
18Electrical Control Module
19Starter power
20Reserve
21Fuel pump, ignition coils
22Air conditioning compressor magnetic clutch
23ECU module and injection system.
24/25Low beam of the left and right headlights respectively.

Next we need to consider the auxiliary block.

NumberWhat is he responsible for?
AReserve
INFuel filter heater relay
WITHReverse light relay
DNot applicable
1Heating system module
2Pre-heating of injectors
3Transmission electronics
4Heating system interface
5Turning on the cooling fan in high speed mode
6Fuel filter heater
7Not applicable
8Electric fan relay monitoring
9Reserve

The following are the power fuses installed on the battery.

Serial numberDescription
1Starter power line
2Power supply for the cabin unit.
3Power supply for relays and fuses under the hood and under the dashboard of the car.
4Generator set and engine compartment relay panel
5Electric power steering column.
6ECU, powering the safety circuits under the hood.
7Switching unit located near the motor.

There is also another panel here.

NumberDescription
1Auxiliary interior heater.
2/3Power supply to the under-dash mounting panel.
4Likewise for the engine compartment.
5Auxiliary heating
6ECU module, ABS and ESP.

The largest number of fuses are installed inside the car.

Serial numberDescription
1/2Reserve
3Cigarette lighter
4Rear socket
5Auxiliary socket in luggage compartment
6Radio tape recorder
7Heated exterior mirror system
8Signal lamp for doors not closed
9Automatic parking brake
10Power supply
11Seat adjustment drive, steering wheel paddle shifters
12Heated passenger seat
13Reserve cell.
14Front passenger door window regulator
15Brake light switch, brake pedal position, ABS and ESP module sensors.
16/17Rear door windows
18Illumination of the glove compartment, doors, rain sensor.
19Dashboard clock, thermometer, radio, seat belt warning lights.
20Air conditioning system.
21Illuminated mirrors in the visors.
22Interior lighting, rain and light sensor
23Trailer group contactor
24Rear wiper
25Rear view mirror in the cabin
26Navigation, radio.
27Radio, parking brake
28/29Reserve inserts.
30Turn signals
31Instrument panel power supply
32Driver's door window regulator
33central locking
34Stock
35Clock, thermometer, standard phone display.
36Diagnostic bus, horn relay, alarm control module
37Brake lights, electrical control module
38Automatic handbrake
39Reserve
40Climate module fan.
41Electric sunroof.
42Rear window defroster power supply

There is also a relay here

NumberPurpose
APowered by battery
INSimilar purpose
WITHRear window heating relay
DKlaxon

Cigarette lighter fuse

The power supply system for the socket on cars of 2010, 2011, 2012 and 2013 is no different from the first modifications. The cigarette lighter is controlled by fusible element 2, mounted in the cabin.

If necessary, some users install an additional socket and connect it to a separate line.

Renault Fluence heater fuse: where is it located?

Insert 7, installed under the hood, is responsible for powering the main heater motor. The control relays of the device are mounted nearby, under numbers 1 and 4.

The motor drive for the additional interior space heater is protected by relays 1 and 5 mounted in the cabin.

Starter fuse and relay

Installed in the engine block at number 19. The corresponding relay is mounted on the positive terminal of the battery at position 1.

Windshield washer fuse

The windshield washer of the car is protected by the interior insert number 8. Another element is responsible for the operation of the windshield wiper.

Pull-in relay Fluence

It is installed on the car in a classic way - in the starter housing. The average price at which you can find a device ranges from 2,500 rubles.

Fuse and fuel pump relay: where is it located?

Power is supplied to the fuel pump through insert 21. The relay is mounted separately. Usually it is installed on the starter.

ABS fuse

The ABS system is powered by two elements. The power part is connected through a fuse element 30 in the motor part. The control controllers are connected to insert 15 of the cabin module.

Fuse for radio

The voltage supply for the standard car radio is provided through modules 19, 26 and 27 located in the passenger compartment.

Reverse

The lamps are protected by fuse 17. The design also includes a power relay C, mounted in the vehicle interior.

Low beam

The headlight power supply system is divided into two parts. Inserts 24 and 25 of the engine compartment are responsible here.

Number plate illumination

The license plate light is connected to the overall vehicle system and is connected to fuse 1.

Trunk fuse

The compartment lid is illuminated through a second element installed in the engine compartment.

Heated rear window

Insert 7 of the motor is responsible for heating. The switch is powered by fuse 42, and the power relay is located in position C under the instrument panel.

Seat heating

The heating system for the front passenger and driver seats is routed through inserts 11 and 12.

Cooling Fan

The system relay is installed in close proximity to the drive.

Renault Fluence: headlight fuse

Fog lights, if present, are protected by insert 4. If there are no additional lights on the car, they are used as a backup.

Voltage regulator

Mounted inside the generator on the drive shaft. To remove it, you will need to disassemble the entire module.

Dimension fuse

Lights are installed separately for each side of the car. The right and left sides are powered from inserts 1 and 2.

Signal fuse

The power part of the line is routed through element 15. The power supply for the push button is routed to insert 16. There is also a brake light relay here. It is also responsible for powering other illuminators.

Air conditioner fuse Fluence: where is it located?

The air cooling system in the car is routed through element 22. From here comes the control of the switches and drives.

Turn signals

The fuse is installed in the car interior under the dashboard at position 30. The relay is mounted there (for the first modifications). Subsequent versions are designed according to a different principle. Here, the comfort unit mounted under the hood is responsible for turning.

Window lifters

For ease of maintenance and simplification, the window lift systems are divided into several branches. The rear lifts are protected by 16/17 inserts. There are also two fuses for the front zone. The driver's side is covered with element 32. The passenger section is routed to insert 14. All parts of the structure are connected through the interior module.

Replacing Fluence fuses

To perform the operation, you will need to follow a certain procedure.

  1. Disconnect the car. If you do not remove the voltage, you can cause a short circuit.
  2. Open the cover of the mounting block and find the required element. To make it easier to find, a schematic diagram of the module is printed on the inside of the protective panel.
  3. Using special forceps or tweezers, remove the damaged element and install a new one in its place.
  4. After replacement, reassemble everything in reverse order.

Subscription to announcements

The magazine "KUZOV" is one of the Russian auto magazines for experts in the auto repair business. On its pages you can find the information you are interested in on all the nuances of the activities of car repair companies, body technologies, methods of coloring and preparing different types of car surfaces, information about paint and varnish and other consumables, car service equipment, and also find out about the latest trends in the modern car market.

Nowadays, due to the fact that auto websites have begun to appear more and more often on the Internet, Russian auto magazines have also become very popular among enthusiasts. And it is often so difficult to find something worthwhile in the midst of all these online notes that will help you not only find all the necessary information, but also become a real guide in the world of cars.

Agree, if you are the owner of a car, then it is more important for you than anyone else to know everything about your own car. You can find out about all aspects of the work, about pitfalls, from our magazine.

Our specialists also regularly travel to events and conferences related to both auto news and retro cars.

We want to invite car enthusiasts who have tasted the taste to pay attention to the business side of the issue - the auto business. How learning actually occurs (the pedagogical process as a result of which students, under the guidance of a teacher, acquire knowledge, skills and abilities)

car service personnel, what new abilities do modern car mechanics have. We will help you not to make a mistake and choose the most reliable car service. We tried to isolate all the most important and fascinating things from the world of cars. After all, any car enthusiast is interested not only in, for example, the development of removing dents from his own car, but also in what new products in the auto business are currently the most pressing.

In the “Press Center” section you can find the latest news and both current and future events from the world of the auto business. In the Season Premieres section, a selection of more expected new products on the auto market. The most noteworthy shots from various auto events are in the Photo Gallery section. Repair work can be seen in action in the Video section.

The publication is understandable in the market of professional printed media (mass media, mass media - periodicals, radio, television and video programs)

more than 8 years. Created for auto market experts, it tells not only about the most pressing news and dilemmas of the industry, but also provides ways to solve them based on the experience of active participants in this market sector.

Broad marketing abilities are ensured by a well-matched, motivated audience of the magazine, a good structure for its distribution in Russia and the CIS countries (the Commonwealth of Independent States is a regional international organization (international treaty) designed to regulate cooperative relations between states that were formerly part of the USSR)

, also with professional editorial content and the highest quality printing.

Thanks to the multilateral and unusual marketing formats used in the magazine, as well as thoughtful information support for the marketing campaign, the greatest placement of the advertiser's brand, products, services and solutions among its possible clients is achieved.

Source: kuzov-media.ru

Rating
( 2 ratings, average 4.5 out of 5 )
Did you like the article? Share with friends:
For any suggestions regarding the site: [email protected]
Для любых предложений по сайту: [email protected]