Hyundai Solaris is a fairly popular car brand in our country. Owners of these cars periodically ask themselves the question: which tires are suitable for the Hyundai Solaris and whether it is possible to supply a non-standard size of wheels and tires.
This article will help answer this question and decide on the choice of tire and wheel sizes, as well as the most suitable brand of winter and summer tires for Hyundai Solaris.
The size of Hyundai Solaris factory tires depends on the year of manufacture of the car, as well as on the configuration. Thus, two tire sizes are installed at the factory:
- 185/65 R15
- 195/55 R16
Where the first numbers are the tire width in millimeters (185 mm and 195 mm, respectively). The second value is the percentage ratio of the tire profile height to its width. And the latter indicates the tire diameter in inches.
The factory equipment for cars in Russia is Hankook Optimo or Kumho Solus tires. By class, the tires belong to the budget category, but Hyundai car owners usually do not have any complaints about quality. Indicators such as wear, controllability and noise levels are within acceptable limits.
Depending on the configuration, Solaris is equipped with either cast alloy wheels or stamped metal wheels equipped with plastic decorative caps. Therefore, the parameters for tires and wheels will be slightly different.
Tire and wheel parameters for Hyundai Solaris with alloy wheels
- 195/55/R16
- Rim width (in inches) – 5.5j
- Bolt pattern (or drilling, PCD) - mounting hole, number of mounting holes per diameter of hole center circles (measured in millimeters) - 4x100
- Disc offset - the distance between the rim mounting plane and the wheel disc mounting plane (measured in millimeters) - ET52
- The diameter of the central hole for the hub is 54.1
Tire and wheel parameters for Hyundai Solaris with stamped wheels
- 185/65/R15
- Width – 5.5j
- Bolt pattern – 4x100
- Disc offset – ET48
- Diameter – 54.1
For visual comparison, the data is presented in table form:
| Disc type | Tire size | Rim width | Sverlovka | Disc offset | Hole diameter |
| Cast | 195/55/R16 | 5.5j | 4x100 | ET52 | 54.1 |
| Stamped | 185/65/R15 | 5.5j | 4x100 | ET48 | 54.1 |
What non-standard tire and wheel sizes can be supplied?
Many owners do simple tuning for their car to make its wheels more impressive or to change the characteristics of the car. To do this, they purchase wheels and tires with a larger diameter than the manufacturer recommends. However, you need to do this wisely, having thoroughly figured out which tires and wheels are suitable for the Hyundai Solaris.
If you reduce the profile height, the car will behave a little differently while driving: handling will improve, reactions to the steering wheel will become quick and clear. But at the same time, comfort suffers: such a car rides harder. This option is suitable for those drivers who prefer a sporty driving style.
As the profile height increases, the result is the opposite - comfort increases, the car drives softly and smoothly, road irregularities pass unnoticed. But the reactions to steering movements become noticeably more sluggish and seem to slow down. This option is suitable for lovers of a relaxed driving style who prefer comfort over fast driving.
However, changing the size of winter tires may have a lesser effect on the car's behavior on the road. When driving on ice, such changes most likely will not be felt at all.
Non-standard tire size for Hyundai Solaris, which should fit perfectly - tires with size 195/60 R15. 195/60 R16 is also suitable.
Available sizes are 195/65 R15 and 205/55 R16. However, with such parameters and the maximum load of the car, the tires can scratch on the fender liners. If driving smoothly and there are no large loads, it should not be noticeable.
In general, the choice of non-standard sizes should be approached intelligently. It is necessary to take into account all possible risks and inconveniences that such a replacement may lead to. This can lead to incorrect operation of the speedometer and odometer and the vehicle's electronic systems (such as ABS, EBD and others). This is due to the fact that the larger the outer diameter of the wheel, the higher the maximum speed of the car and the lower its acceleration dynamics, and vice versa. Also, changing tire size can affect the wear of some suspension and steering components.
Which tires to choose for the summer
In the summer, the overwhelming majority of Hyundai Solaris drive on 185/65 R15 tires. Therefore, when choosing wheels on the eve of the summer season, we will take this size as a basis and, as always, turn to the results of tests conducted by some authoritative magazine or club specializing in such issues.
Summer Tire Marathon 2019
In our case, it will be the German auto club ADAC, which held the 2022 marathon for tires of the above size. Tires from 16 manufacturers took part in the test.
Its results turned out to be quite unexpected in the sense that some premium brands, which previously always occupied the first lines of the hit parade, moved down, giving way to tires from the medium sector.
Four rating categories were used: good, satisfactory, unsatisfactory and mediocre. Only two participants received the highest rating of “good”; all the rest received “satisfactory”. Fortunately, there were no lower ratings.
Let's look at the breakdown of participants based on the results of the auto review:
Bridgestone Turanza T005 (1st place)
The main surprise for the organizers of the auto review was Bridgestone, which took first place, since the summer tire of this brand rarely received prizes at such events.
But this time Turanza T005, which debuted the year before, 2022, broke all records, becoming the best on both dry and wet roads. And this is more than pleasant, considering that the previous model of this brand (Turanza T001) 3 years ago could only take 12th place.
Vredestein Sportrac 5 (2nd place)
The brainchild of the Russian-Dutch concern Vredestein, which today owns two Russian tire factories - Voronezh and Kirov, was able to approach the results of the Japanese Tyuranza.
True, the Sportrac 5 tire, which participated in testing, is produced in the Netherlands. It was only slightly inferior to the Bridge, and together with it was awarded a “good” rating, captivating the judges with its resistance to wear and excellent grip on wet roads.
Michelin CrossClimate+ (3 m)
Since all-season tires are still more summer than winter tires, they were also allowed to compete. These include the French-made Michelin CrossClimate+, which took an honorable third place in this race.
Tire pressure
Tire pressure level is one of the most important indicators that determine the behavior of a car while driving on the road. Road traction and, in general, driving safety depend on tire pressure. Therefore, it is recommended to regularly measure tire pressure. The manufacturer recommends carrying out such a check simultaneously with refueling the vehicle. To do this, it is useful to keep a pressure gauge in the trunk. This way you can avoid rapid wear of the rubber.
Recommended tire pressure for Hyundai Solaris: 2.2 Bar (or 32 psi) for rear and front wheels. In other words, about 2.2 atmospheres. For full load, the manufacturer recommends maintaining the same pressure. This data is indicated on a plate located in the driver's doorway or in the operating manual.
Low tire pressure can lead to some unpleasant factors:
- Fuel consumption increases;
- Vehicle dynamics indicators decrease;
- Car handling deteriorates.
Tire pressure should only be measured when the tires are cold, otherwise the readings will be incorrect.
Recommendations for disc care
- Check the geometry and wheel balancing on a special diagnostic stand. If deviations are detected, restore the integrity of the structure at a service station. It is impossible to “reanimate” the disk on your own due to the lack of necessary equipment;
- Immediately contact a service station for preventive maintenance if you find cracks or dents on the rim;
- Avoid getting into potholes, especially at high and medium speeds. The disk will be deformed, the seal will be broken, regardless of the material of manufacture;
- Monitor the tire pressure; it should not differ from that recommended by the manufacturer. If there is a deviation, pump it up yourself, contact the service station;
- Observe the transition to summer and winter modes. In summer, the tire pressure is 0.15 atm higher, in winter it is lower by the same amount. The parameters are specified in the vehicle operating instructions;
- Tighten the rim nuts with a torque wrench. Excessive tightening contributes to the breakage of the studs, weak - to the unscrewing of the wheel and a collision on the road.
In sunny weather, cast aluminum wheels are least susceptible to external damage. But in slush, ice, when the road is strewn with various chemicals, the rim is susceptible to corrosion. This provokes paint peeling and destruction of the molecular composition.
Wash your wheels as they get dirty. Since it is unlikely that you can clean it properly with a rag, use high-pressure compressors. Equipment of this class is available at many service stations, workshops, and service centers.
Systematic polishing allows you to get rid of scratches and burrs. First clean the wheel from dirt, dry it thoroughly, and then treat it with a chemical. Wipe several times with a microfiber cloth.
Store wheels in a hanging position, do not stack them on top of each other. Clean off any dirt, dry, and wrap in cellophane. Some motorists practice applying an aerosol to the surface before preservation. However, this is a purely personal decision of the owner.
More about Solaris
- Hyundai Solaris tires: standard and permissible tire sizes, pressure
- Hyundai Solaris Wheel Sizes – Size Charts
- Tires for Hyundai Solaris: how to choose, basic sizes and pressure control, manufacturer's recommendations, test results and owner reviews
- Bolt pattern for Hyundai Solaris – Auto magazine Acord-Auto
- Procedure for replacing the wheel stud of Hyundai Solaris step by step instructions
- Procedure for replacing the wheel stud of Hyundai Solaris step by step instructions
- Bolt pattern for Hyundai Solaris – Automagazine MyDucato
- Replacing brake discs Hyundai Solaris
- Procedure for replacing the wheel stud of Hyundai Solaris step by step instructions
- What is better Hyundai Solaris or Audi A4
Pressure meter. How to disable it
Hyundai Solaris cars are equipped with a system for indirect measurement and monitoring of tire pressure. A sensor in the ABS system is responsible for this, which reads the wheel speed. The system monitors the difference in revolutions between wheels with a set rotation value.
When descending, the wheel reduces its radius and therefore rotates a little faster. It turns out that in one revolution a good tire travels a greater distance than a flat one. The sensor signals are compared in the ABS unit with control values. The system notices a discrepancy in values and reacts to this with an audible signal and an indicator on the dashboard.
There are no pressure sensors installed in the wheels themselves, so you can change them without fear. However, after replacing the wheels or as a result of service work, the indicator may light up, even if the tire pressure is fine. How can I disable this error? In this case, you must turn on the ignition and press the sensor initialization button for 3 seconds. This will complete the setup of the sensors and you will be able to continue driving with the new rims without any problems. The sensor now works with the new parameters.
Wheel bolt pattern
The bolt pattern of the Hyundai Solaris is another important point when choosing wheels. This parameter is sometimes also called drilling. It consists of two numbers of the form X*X and is denoted by the abbreviation PCD in disc labeling. Shows the number of bolts on which the wheel is attached and the diameter of the circle on which they are located. On passenger cars, four to six studs are typically used.
For Solaris, the PCD value is 4*100, which means that the wheel is mounted on four bolts located on a circle with a diameter of 100 mm. The wheels of the Kia Rio, a classmate from another Korean manufacturer, have the same bolt pattern. The hub hole in the disk has a diameter of 54.1 mm, the thread on the studs is M12*1.50. This type of thread is widespread and is found on many cars. Its value should help when choosing flare nuts for securing wheels. The hub hole may be larger than specified.
2011-2014
The first generation Solaris are a sedan and a five-door hatchback with an I4 engine.
5.5Jx14 ET43 – for these discs the offset range ranges from 35 to 45 mm. This is the factory size for first generation cars.
Helpful information
Settings
Connect with us
About the site
Wheel Size is a reference book of factory tire sizes and wheel parameters. We strive to provide all the information you need about the standard wheel sizes for your car and replacement options.
Please keep in mind that although much of this information is taken from vehicle manufacturers' websites, this catalog is for informational purposes only and does not guarantee that the dimensions offered will fit your vehicle.
Almost every Russian car enthusiast is familiar with the Korean brand Hyundai, which has gained popularity in the country since the end of the last century. Hundreds of different models of all known classes of passenger vehicles rolled off the assembly lines of numerous factories of this auto giant. The most famous model of the brand has always been the Hyundai Accent. And the equally famous Solaris, whose production started in 2011, became even more popular as one of the modifications of small city cars, adapted specifically for operation in the harsh climate of the Russian Federation.
A little about the car
Eight years is a sufficient period for car owners to comprehensively study and evaluate any car. And if the decision is made to release the next generation, it means that everything went as it should, sales are going well and all that remains is to take into account the opinions of the consumer, making the car even better. This is exactly what happened with the Hyundai Solaris.
Since this is a small class B city car, it was equipped with only two options for small engines - 1.4 and 1.6 liters. The first option, with a power of only 107 hp. was not in great demand, and therefore the number of its sales was significantly lower.
However, to work with a more powerful 1.6l engine, the automatic transmission was clearly not enough, which was the reason for some modifications to the model.
In particular, Hyundai has modernized the rear suspension several times, which has helped improve the car's stability when driving and eliminate sway on poor-quality road surfaces.
In the basic configuration, Solaris was equipped only with a 1.4 liter engine with a manual transmission, steel wheels (wheel diameter 14 inches) and only one airbag. No other security systems, including anti-lock ones, were installed on them.
Solaris 2011 (1st generation)
Three years later (in 2014), the car was restyled, and in the middle of the year the updated version was already on sale. The changes affected the gearbox, which added the number of steps, an electrical part, a steering wheel that became conveniently adjustable for reach, and new body painting options appeared.
