Timely replacement of the air filter is an indispensable condition for proper operation of the car.
- Replacing the air filter. Video:
A worn filter can cause the following serious problems:
- reduction of compression in the cylinders of an internal combustion engine due to dust entering the combustion zone and the formation of scuffing;
- premature valve wear;
- contamination and failure of the mass air flow sensor;
- jamming of the throttle valve;
- reduction of internal combustion engine torque;
- problems with starting, especially in the cold season.
During the operation of the car, it is important to promptly and competently replace the device and know the main signs of its contamination.
How often should you change your air filter?
According to the maintenance regulations for most modern cars, the air filter needs to be changed when the car's mileage reaches from 35 to 50 thousand km. These numbers are significantly overestimated because a number of factors are not taken into account, such as:
- environmental situation in the region
- operating conditions of the vehicle.
It is also worth noting that foreign car manufacturers, when drawing up these regulations, focus on European ecology, while on Russian roads the level of air pollution is much higher.
Therefore, the air filter replacement interval can be significantly shortened. This is especially true during the warm season.
The average frequency of replacing the air filter is once every 10 thousand km. vehicle mileage.
Signs of a clogged air filter
If the filter is heavily clogged with dust, the following changes occur in the operation of the car:
- loss of engine power;
- increase in car fuel consumption (from 10%);
- increased levels of carbon dioxide in exhaust gases.
At the first appearance of these symptoms, it is recommended to replace the filter as soon as possible. But it would be most advisable to prevent the above symptoms from appearing. To do this, it is recommended to regularly monitor the condition of the filter element.
Where to look for it
How to replace the cabin air filter? If it's located in a convenient location, then it's easy. Most often, cabin filters are located inside/behind the inner wall of the glove compartment. It is not difficult to replace it. It is enough to remove the glove compartment (you don’t have to completely remove the dashboard) to get the element; instructions should be in the manual.
If the filter is deep under the dashboard, it will be difficult to get there, and there is no way to do this without specialists. There are also those located in the space under the hood, then replacing them is not difficult. Here, too, there is no point in bothering with purchasing an expensive original.
It’s easier to purchase an affordable analogue at your local store, just like a regular filter.
That’s all for me, friends, at what mileage filters are changed you now know, and you can replace them, subscribe to site updates, and recommend that your friends subscribe, they might find it useful, share links to this article and others, see you.
Is it possible to clean the air filter?
When the filter's capacity is reduced, it becomes subject to higher physical stress, which may result in its deformation. Road dust will begin to penetrate the engine, shortening its life.
The filter element has its own service life. It is impossible to knock it out or clean it. Although a washed filter may appear clean visually, tiny particles of dust, invisible to the eye, are retained within the filter material.
Therefore, regular replacement of the air filter is recommended.
To replace the device, you can contact an authorized dealer or perform this procedure yourself. The cost of a new filter element is relatively low, so regular updating is affordable for everyone.
How to replace the air filter yourself?
Before you begin installing the air filter, you must consult your vehicle's owner's manual, as you will need to purchase a filter similar to the one installed on your car's engine. If you do not have these instructions, you can find information on the Internet or seek help from a specialist.
As a rule, changing the air filter yourself is not difficult. This procedure is extremely simple and takes about two minutes.
Where is the air filter located?
The installation location of this filter depends on the car brand and engine type.
- On carburetor-type engines in cars such as ZIL, as well as older domestic models, it is installed inside the air intake.
- On injection-type engines in such cars (most models of Hyundai, Lada Priora, Mazda, BMW, Renault, KIA and others), the air filter is installed inside a plastic housing, from which a corrugated hose extends.
Why does he even
For normal engine operation, a car needs not only fuel, but also air. Without it, fuel combustion will be incomplete or not at all. The cleanliness of the air is insufficient, therefore, in order not to pollute the motor with dust, plant seeds and leaves, and other debris from which it will break down quickly, an air filter was developed. Because engine cleaning and repairs are a long and expensive procedure.
Like other filters, it must be changed promptly.
How to change the air filter: step-by-step instructions
- First you need to apply the handbrake and turn off the engine. If you have a manual transmission, engage first gear. If your car is equipped with an automatic transmission, put the car in “park” mode.
- Then you should open the hood and secure its lid using the lever.
- On some car models, a brake vacuum hose is connected to the filter housing. It should be carefully disconnected.
- Next, you need to remove the air filter cover, usually located on the top of the engine. The cover is most often secured with four or five screws. Therefore, you will need a regular Phillips screwdriver or a socket wrench. Some car models use clips or wing nuts instead of screws.
- Next, you need to remove the old filter element.
- Before installing a new air filter, you must use a damp cloth to remove any dust and dirt that has accumulated there from the housing.
- Next, you should install a new air filter in the housing, as shown in the figure. It is necessary to position it with the wide part up and press it tightly so that there is no gap between the housing and the filter element.
- Then you need to carefully press the filter with the top cover and secure it with screws, nuts or clips.
Recommendations
- It is worth remembering that if the car has been driven recently, some components located under the hood may be hot.
- Whenever you replace the air filter, you should inspect the corrugated hose that connects the throttle body to the filter housing for cracks, tears, and gaps. If there is a crack in the hose, dust enters the car engine.
- After several trips, it is recommended to check the filter element for contamination levels. If dust accumulates on the rubber rim, the filter element was not installed tightly enough.
- On diesel engines, the filter housing is equipped with a special clogging sensor, making it easier to monitor dust levels. After each filter element replacement, the sensor knob must be turned in the direction of the arrow. It is recommended to replace it when the needle reaches half of the scale.
Classification
Considering how often the engine air filter in a car is changed, it should be said that there are several classifications of these parts. To choose the right one or another, you need to choose the option that is suitable for a particular car.
Filters vary in shape. They can be flat, square, round, etc. Based on the method of filtration, there are direct-flow, inertia-oil, and cyclone filters. Depending on the operating conditions, there may be heavy or ordinary cleaners. Filters also vary in the level of their deterrent capabilities. They can be single or multi-stage.
This diversity is explained by the constant development of technologists in the field of extending the performance characteristics of the car. New views on the problem of ensuring high-quality air purification are constantly emerging. But older car models work with those versions of filters that were developed by the manufacturer at the time the vehicle was produced.
Air filters "DIFA" - high quality at competitive prices
When you replace the air filter, you should pay attention to the manufacturer of this device. By purchasing high-quality filter elements, you protect your car engine from premature wear.
DIFA-AVK LLC has been supplying filters for cars and trucks for more than five years and is the official distributor of the famous Belarusian company. These filter devices are very popular in Russia and the CIS countries. Thanks to the use of modern technologies, DIFA air filters are capable of eliminating up to 99% of contaminants, providing reliable engine protection. These devices are certified ISO/TS16949.
We offer a large selection of filters for any brand of car at competitive prices. It is also possible to manufacture custom-made air filters.
Air filters for passenger cars
There are two types of air filters used in passenger cars:
Round or oval. Installed on carburetor engines. To strengthen the filter partition, they are equipped with a metal mesh with an anti-corrosion coating.
Panel. The most common type. As a rule, these air filters are installed on injection engines. They do not have metal elements in their design, which ensures additional reliability of engine operation, reduces the emission of harmful substances into the environment, and also simplifies the disposal of the filter element.
Catalog of filters for domestic passenger cars
Our website presents over ten different types of air filters for Russian-made cars at prices ranging from 50 to 325 rubles.
Catalog of filters for imported passenger cars
Our catalog contains more than sixty types of air filters for foreign passenger cars at prices ranging from 68 to 405 rubles.
Basic mistakes when replacing
It would seem that installing a new filter is one of the simplest car maintenance procedures. Unfortunately, many even here manage to make a number of mistakes. Let's take a look at the most popular ones below.
The first common mistake is not to try to restore the old filter. The owners begin to wash the filter honeycombs, trying to clean them as much as possible from accumulated dirt. This is strictly prohibited. The reason lies in the behavior of the production materials. For effective cleaning, honeycombs are made of paper. It's easy to guess what will happen to it when water hits the surface. By installing such a filter back, the engine will begin to perform significantly worse. A so-called “lean” occurs when too much air enters the combustion chamber. And it definitely won’t be clean.
The second mistake is ignoring traces of oil. There should be no liquid inside the work area; motor - even more so. The presence of oily traces indicates a problem with the engine lubrication system. If you install a new filter in its original place, it will not last long. After a breakdown, the car must be sent to a service station for repairs. Technicians must check the condition of the engine and what exactly needs to be changed in it in order to avoid further oil entering the filter area.
The third common mistake is using non-original, and what’s worse, uncertified products. The first option is allowed if the filter is produced by a company that does not work directly with the manufacturer. That is, whose products are not used as standard at the factory. If there is a certificate, it means that the car brand has approved the model for use, but the owner assumes all risks regarding its performance. You should not pay the slightest attention to products without a certificate. The reason is obvious - they will not be able to work as well as licensed products. The use of non-original, uncertified filters will result in rapid engine failure. Moreover, this can happen at any mileage, be it 500 or 25,000 kilometers.
