Changing the oil in a Granta automatic transmission: procedure and what to pay attention to

As is the case with a car engine, the oil in the Lada Granta automatic transmission needs to be regularly checked, updated and completely replaced if necessary. To avoid having to perform expensive transmission repairs, motorists need to know how to check, what to look for, and how to change the oil in an automatic transmission themselves.

Replacement

  1. We place a suitable container under the box and wipe the surface around the perimeter of the drain hole.
  2. Unscrew the nut (plug). The oil flow is not as intense compared to “mechanics”. Therefore, it is necessary to unscrew another nut located at the top of the unit.

Some owners of Lada Granta resort to the procedure of washing the box. To do this, use kerosene or diesel fuel. Due to the intense saturation of the oil with particles, even a small portion of it remaining in the unit can saturate the “new” lubricant with an unwanted “metallic additive”.

What kind of oil is in Lada Granta automatic

Changing the oil in an automatic transmission on a Grant

The requirements for the quality, composition and quantity of lubricant are very high. Oil life is highly dependent on operating conditions and can vary from 30,000 miles (50 thousand km) to 120,000 miles (200 thousand km).

If there is an increased load on the transmission (driving on bad roads, a fully loaded car, constant driving with a roof rack), it is necessary to regularly check the oil in the Granta automatic transmission to see if it needs partial or complete replacement. Information about what kind of oil can be filled into the Lada Granta automatic transmission is provided by the manufacturer.

Original oils

The manufacturer of the Jatco JF414E gearbox, Jatco, recommends using only Nissan ATF Matic-S 999MP-MTS00P transmission fluid of its own production for operation in the unit. It's quite expensive.

Lubricant analogues

There are alternative options for transmission fluids that are similar in parameters to those recommended by the developer. Therefore, changing the oil in an automatic transmission on a Grant can be done using an analogue that corresponds to the Matic-S classification, such as, for example, the following oils:

  • Castrol Full Synthetic ATF;
  • Castrol Transmax™ DEXRON®-VI Automatic Transmission Fluid;
  • Valvoline MaxLife Multivehicle Synthetic ATF.


Oil in automatic transmission Lada Granta

All of them, including Nissan ATF Matic-S 999MP-MTS00P, are the same substance for working in automatic transmissions, but under different brands.

Top 3. LUKOIL TM-4

Rating (2021): 4.45

120 reviews from resources were taken into account: Ozone, Yandex.Market, Otzovik

Wide temperature range All-season oil retains its properties both in 40-degree frosts and in 45-degree heat. A universal option for most Russian regions.

  • Characteristics

    Average price: 426 rub./l

  • Country Russia
  • Type: semi-synthetic
  • API Standard: GL-4
  • Viscosity: 75W-90

Thanks to a highly effective additive package, the oil has high anti-wear and anti-corrosion properties, as well as thermal-oxidative stability. All-season semi-synthetics with a viscosity class of 75W-90 are suitable for use in many regions of our country. The temperature range in which the oil must maintain its frictional properties is from -40 to +45 degrees. Unfortunately, some drivers notice that at minus 25-30 the first time after starting the gears “stick” very tightly. Most buyers like the price of the product and the way the manual transmission works with it.

Advantages and disadvantages

  • Affordable price
  • Wide temperature range
  • Smooth gear shifting
  • Freezes in extreme cold

Engine (Rosneft 5W-30)

From the factory, the engine of the Lada Granta car is filled with Rosneft semi-synthetic oil 5W-30 . There is no such oil on the market, since it contains special additives that serve for better running-in of the new engine.

8 valve

8-valve engine (87 hp)

On an 8-valve engine, zero maintenance must be done at 2,500 km , since the valves need to be adjusted there. It is at this mileage that the oil is changed to a new one, and the old, break-in oil is drained.

16 valve

16 valve engine (98 hp)

And on a 16-valve engine, zero maintenance is carried out only at a mileage of 15,000 km, so some owners themselves change the oil at a mileage of up to 5,000 km . But there is no definite answer here, since car enthusiasts have different opinions.

List of replacements

List of recommended engine oils for the engine

Video about choosing oil (engines are similar)

How to choose your own motor oil?

Consequences of overflow

This phenomenon can have a very negative impact on the gearbox. When oil is in excess, it tends to foam. This condition leads to a loss of lubricating properties, since air begins to “lubricate” the part instead of oil. The result is failure of the automatic transmission, since the parts begin to burn without receiving adequate lubrication. In addition, foaming causes transmission fluid to leak through the breather.

You can check the condition of the box by carefully inspecting the oil fluid. If the automatic transmission is not damaged and operates normally, the lubricant is red in color, the liquid does not contain any dark-colored foreign particles, such as solid particles. If the ATF is dark in color and smells burnt, the automatic transmission is destroyed. The solid particles that can be seen on the dipstick are the result of the destruction of the clutches and brake band.

Design features of the Jatco automatic transmission

Lada Granta cars are equipped with a four-speed automatic transmission Jatco JF414 (AY-K3). The characteristics of the new car are as close as possible to international standards. The Lada Granta gearbox is equipped with a reliable hydraulic unit.

The technical capabilities and operational properties of this automatic transmission are excellent for modern domestically produced cars. The gearbox is protected from overheating; reliable protection is triggered when it reaches +114°C. Sensor readings below this parameter are considered normal for further movement. The Grant gearbox is controlled using an electronic control unit (ECU).

Sequence of oil change steps

Changing the oil in the Lada Granta automatic transmission on a regular basis will help extend the life of the automatic transmission.

In addition, the condition of the drained oil in the Lada Granta automatic transmission will signal the presence of some problems, the accounting of which may require additional inspection or repair of the corresponding components.

Indicative signs of problems are shown in the table:

Color of drained fluidPossible problem
Dark or black, with a burning smellWear of friction elements
Milky pinkPenetration of water from outside through the filling tube or breather
Sticky, light to dark brown in colorOxidation - overfilling or underfilling of liquid. Overheat.

Changing the oil in the Lada Granta automatic transmission involves removing the oil pan and the oil filter cover, followed by replacing it or thoroughly washing it.

To change the oil in the automatic transmission of a 16-valve Lada Granta, you will need the following tools and consumables:

  • keys (heads) at “10”, “19” and an L-shaped hexagon at “5”;
  • hose with funnel;
  • lint-free rags, hard brush;
  • container for draining used oil;
  • inspection hole, overpass or lift;
  • anti-recoil shoes.


Changing the oil in the automatic transmission of a 16 valve Lada Granta

To drain the oil, the following preparatory procedures must be carried out:

  1. Start the engine and let the gearbox warm up until the fluid reaches operating temperature (HOT mark on the dipstick at a temperature of 50 °C to 80 °C).
  2. Turn off the engine.
  3. Remove the air filter (not completely, just to make room for access to the dipstick for checking the fluid level in the automatic transmission).

The last step is to move under the car and remove the engine crankcase protection for easy access to the box pan.

Draining waste fluid

To drain the transmission fluid, do the following:

  1. Using a key set to “19”, unscrew the plug on the transmission pan.
  2. Carefully pour the used oil into the prepared container (please note that this is only a part that should be taken into account when calculating the amount of fresh transmission fluid to be subsequently poured).
  3. Place the long end of the L-shaped hexagon at “5” into the hole from the unscrewed plug and, aligning it with the socket of the overflow tube, carefully unscrew it and rinse it.
  4. After waiting for the oil to stop leaking from the drain hole, proceed to remove the pan, which is secured to the box with 16 identical bolts through a gasket, which is recommended to be replaced during reassembly.
  5. Using a “10” head, unscrew 16 identical mounting bolts of the pan (it is better to unscrew the bolts around the perimeter first, and the corner bolts last, to avoid a sudden release of the hot oil contained in it due to sagging of the pan).
  6. Having removed the pan, proceed to unscrew the 12 bolts of the oil filter cover (the bolts are of different lengths, so it is important to mark their location around the perimeter so as not to damage the mechanics during reassembly). It should be borne in mind that there is also a certain amount of transmission fluid in the filter cover, which must be taken into account when calculating the required volume.

The removed pan and cover are thoroughly cleaned, and the filter is replaced.

Washing the tray and removing chips

At the bottom of the pan there are 2 magnets that hold metal particles that enter the transmission fluid as a result of running-in and partial wear of the friction elements of the mechanism.


"Lada Granta": changing the oil in the automatic transmission

They need to be completely cleaned in the same way as the pan itself, using suitable rags and gasoline.

Replacing the automatic transmission filter

In Lada Granta cars, changing the oil in the automatic transmission is accompanied by installing a new filter. Sometimes you can leave the old one by rinsing the mesh well in gasoline and removing the metal filings. This will ensure correct operation of the oil pump.

Adding fresh oil

Having installed the parts removed and cleaned of old oil and metal filings in the reverse order (observing the correspondence of the bolts and their seats in the filter cover), they begin to fill fresh transmission fluid through the oil receiver, which also serves as a tunnel for the dipstick, in a volume equal to that drained.

Very important : the amount of liquid poured must exactly match the drained volume. The automatic transmission manufacturer warns against exceeding its level.

After filling, start the engine and check all connections for leaks from under the crankcase cover fastenings. With the engine idling, holding down the brake pedal, move through all positions of the driving mode selection lever. And finally, having stopped in position “P”, they begin to check the fluid level with the power unit idling:

Where did this opinion come from?


According to legend, when a future driver is just studying at a driving school, he learns this “life hack” for manual transmission and arguments in its favor from instructors of varying degrees of advancedness.
The trick is that if you depress the pedal before starting the engine, you will avoid a jerk and a possible impact with the car in front, and also make it easier to start the power unit by removing the load from the gearbox. The first argument applies mainly to situations where a novice driver is trying to get out of a tight parking lot and starts the car in gear. But many readers remember their training in a driving school, how the instructor “trained” them to always check neutral before turning on the ignition and explained why they actually squeeze the clutch before starting the engine.

Rating
( 1 rating, average 5 out of 5 )
Did you like the article? Share with friends:
For any suggestions regarding the site: [email protected]
Для любых предложений по сайту: [email protected]