Replacing the Daewoo Nexia fuel filter: photos and videos

Changing the engine oil

When changing the oil, you should take into account the mileage and duration of use of the oil in the engine. The properties of the oil deteriorate not only during vehicle operation, but also during the natural aging process of the oil. If you frequently start a cold engine or constantly drive in heavy city traffic with frequent stops, the oil and oil filter should be changed earlier than the period specified in the maintenance schedule. The frequency of oil changes is every 10 thousand kilometers or six months. In difficult operating conditions - after 5 thousand km or three months. When changing engine oil, the oil filter should be replaced. We change the oil with the engine fully warmed up. We carry out the work on an inspection ditch or overpass.

Fuel filter location

The fine fuel filter is located on the Daewoo Nexia under the bottom of the car. It is located on the right side.

Location of the fine fuel filter

The coarse mesh is assembled with the fuel pump. The pump is placed directly into the gas tank.

Location of the coarse mesh

Sergey Fedorov_

Sergey Fedorov, editor:
— When operating the Daewoo Nexia or any other modern car, make it a rule to periodically monitor the level and cleanliness of the engine oil in the engine. Neglecting this simple rule can lead to unplanned expenses. The fuel filter should be updated at least once every 30 thousand km. And if operating conditions are difficult, even more often.

We service Daewoo Nexia: for cleanliness and lubrication...

Article number and approximate cost of a branded fuel filter and its analogues

The Daewoo Nexia has a fine fuel filter. It is the same regardless of whether the car engine has 8 valves or 16 valves. The original consumable has one of the following catalog numbers:

• 96130396;
• 25055129;

The cost of a native fine filter ranges from 500 to 750 rubles. Analogs of the branded filter are also available for sale. The best alternatives are shown in the table below.

Table - Analogues of the fine fuel filter for the Daewoo Nexia car

In addition to the fine filter, the Daewoo Nexia has a mesh that catches large debris. On cars manufactured before 2002, the filter mesh used has article number 96183953.

A branded coarse filter costs from 160 to 220 rubles. It is also possible to buy analogues from other brands. The table shows the best nets for cars produced before 2002.

Table - Alternatives to native mesh 96183953

Daewoo Nexia cars manufactured after 2002 use a mesh filter with catalog number 96350078-2. The cost of a branded mesh ranges from 30 to 80 rubles. The best analogues of filter mesh can be found in the table below.

Table - Analogs of mesh filter 96350078-2

In some cases, instead of replacing the filter mesh, it is more profitable to install a new fuel pump assembly. For Daewoo Nexia cars produced before 2002, a unit with article number 96350078 is required.

The price for consumables varies from 1000 to 1800 rubles. There is also an opportunity to purchase an analogue online. The best alternatives are presented in the table below.

Table - Analogues of the Daewoo Nexia branded fuel cup until 2002

On Daewoo Nexia cars produced after 2002, the fuel filter is 96494976. Its cost varies from 2,700 to 3,000 rubles. The best analogues of the native node are given below.

Table - Analogs of the original fuel module for Daewoo Nexia after 2002

Mesh

Preparing to replace the filter

The first step is to prepare tools and materials, for example, a fuel filter can be ordered on the Internet, and for this our article with numbers for filter consumables may be useful. (see article for Nexia filters).

Also, replacing the fuel filter on a Nexia has one feature. It is necessary to buy rare keys for 16 and 21.

– keys for 13, 14, 16 and 21;

– copper washers (suitable from a vase, in case they are not included with the new filter)

– 200 ml container for draining gasoline

Fault diagnosis

It is worth noting that monitoring the service life of a fuel filter is quite difficult, inconvenient and not always accurate for correctly determining the stability of the unit. As a result, when checking the serviceability of the Daewoo Nexia fuel filter, emphasis should be placed on the behavior of the car. In the case of “clogged” filter elements during the operation of the model, the following will be observed:

• problems with fuel consumption, naturally, on the increase;
• Unstable engine operation at idle;
• poor engine starting;
• problems while driving - from insignificant tripping to pronounced jerking.

Important! Of course, the presence of such symptoms may also indicate a breakdown of other components of the car. However, as practice shows, when the symptoms described above appear, it is the fuel filter that should be checked first.

Such signs are worthy of special attention in the case when the fuel filter of the Daewoo Nexia has not been changed for a long time. Do not forget that operating a machine with a “clogged” filter significantly reduces the service life of its motor.

Where and when to change the fuel filter on Daewoo Nexia

The Nexia is equipped with a full-flow fuel filter, which is located in the rear of the car next to the fuel tank and is attached to the longitudinal beam with a special clamp. The fuel line pipes are screwed using threaded connections. The filter is a cylindrical steel housing, inside of which a filter element is located.

Gasoline sold at gas stations is not of excellent quality and often contains various impurities. And containers that are used to store and transport fuel are subject to various contaminations, as a result of which rust and contamination can get into gasoline. All of these factors negatively affect the quality of fuel.

To protect the fuel system from the occurrence of corrosive processes and premature wear, the vehicle is equipped with a filter element. The main function of which is to clean the fuel from impurities and foreign particles. When the car filter is clogged, then it will appear as follows:

loss of vehicle power;

increased fuel consumption;

poor starting and unstable engine operation;

• At high engine speeds jerking occurs.

If the above malfunctions are detected, it is necessary to replace the fuel filter. According to the service book maintenance regulations, the filter element should be replaced every 10,000 km. Simple and clear, you can even make it a rule that with every oil change you should also replace the fuel filter.

Replacing the fine fuel filter

Replacing the fine filter is shown below.

• Relieve pressure in the fuel circuit.
• Clean the fuel filter from external dirt.

Work area to be cleaned

• Unscrew the pipes.

Disconnecting the fuel line

• Loosen the clamp.

Unscrewing the pinch bolt

• Remove the filter.

Pulling out the filter

• Replace the O-rings.

O-rings

• Install a new filter.

New consumables

Installation

• Check for leaks.

Sensors that make it impossible to start a Nexia

The sensors in the Nexia are not only responsible for the formation of the fuel-air mixture, but some sensors can prevent the engine from starting.

Crankshaft position sensor - affects engine starting. A break in the chain, as well as its incorrect operation, will not allow you to move even a millimeter!

Idle speed sensor - indirectly affects engine starting. The situation is as follows: You are trying to start the engine, and it seems to catch, but no, it immediately stalls. This inexpensive sensor may be to blame.

Absolute pressure sensor - on some versions of Nexia it affects starting the engine in cold weather. A vacuum tube goes from the sensor to the inlet, in winter condensation forms in it and the engine simply does not start!

The SCT ST330 fuel filter does not fit the Nexia N150!

, they oil a couple, I didn’t collect the rest.

We've arrived. I went straight to the garage, fortunately my father had made a hole.

At least I'll see what's going on underneath me. While the car was standing

, examined the bottom of the car

, cleaned all visible nuts and treated them with a mixture of CV joints + autoplasticine

, because the autoplasticine simply peels off from the surface. Well here is the filter

Also, while I was cleaning the fuel pipes from auto plasticine, I noticed pockets of corrosion

, cleaned the areas and covered with alkyd primer

. Then I unscrewed and removed the fuel filter.

, replaced the rings on the fuel pipes

. I attached a copper ring from the filter, but it doesn’t fit on the tube.

And... taking a new filter, they try to put the tubes in, no infection comes out... pulled it out... tried again... Then I compared the old and the new...

Well, here I am... okay, I didn’t throw the old one away... The holes are wider on the filters for Nexia... I wanted to take the new filter at first... but the box

...and there is no receipt. Okay, I’ll give it to my wife’s brother, he has Viburnum 1 sample that might come in handy... I had to return the old filter, secured it and sealed it with auto plasticine.

By the way, I unscrewed it at the beginning without any problems either, all because it was protected with auto plasticine. I’ll buy the original later or an analogue based on reviews and tests. And I’ll go to that store and say that the filter didn’t fit, although they said there was one for Nexia, I said on the thread without latches... I looked, read, sold, and the result didn’t fit... There’s also a filter in the tank, but there’s no gasket, so it doesn’t work. Later I’ll start inspecting the bottom, etc.

Source

We carry out the replacement ourselves

Deu Nexia cars, like any other cars, require refueling only with high-quality gasoline.
Unfortunately, it is difficult to find one at domestic gas stations, as a result of which the car owner has to carry out technical work to replace certain parts more often. Here we are talking about the Nexia fuel pump filter. You can carry out such repair work yourself, and today you will learn how to do it. Old and new mesh filter element for the fuel pump of the Daewoo Nexia

Please note: the car's operating manual does not say anything about replacing the filter element. That is, the manufacturer installed the filter for the entire life of the car.

But given the low quality of Russian gasoline, experts recommend replacing the filter mesh or at least cleaning it at least every 20 thousand kilometers.

What to cook?

First of all, you should prepare thoroughly. Keep in mind that when you disassemble the fuel pump, going to the store to get something missing will be problematic, so it’s better to prepare everything in advance. So, you will need:

• wrench 8;
• Gasket for fuel pump;
• new mesh for the filter element.

Loading …

Instructions

Before you begin to replace the fuel pump filter, you must relieve the pressure in the system. To do this, start the engine, and then find the relay on the fuse box that controls the fuel pump. Remove it from the socket: after some time the car should stall. When this happens, disconnect the negative terminal of the battery.

The fuel pump in the Daewoo Nexia is located in the rear of the body under the seats. To get to it, you need to remove the rear seat. To do this, you need to press the seat cushion towards the trunk and at the same time lift it slightly. After removing the seat, under the carpet we will see a hole for the fuel pump

By picking up the plastic plug with a screwdriver, this part can be removed. Then you should unscrew the clamp with which the pipe is attached to the fuel pump. Having done this, you can disconnect the power cords of the unit. Now carefully, without applying additional force, use pliers to disconnect the pipe from the fuel pump. At this moment, the device can be turned a little in different directions so that the hose suitable for it does not break.

The relatively small space will not allow you to conveniently dismantle your pump, so you will have to work hard here. After this, when the pipe and wires are disconnected, use an 8-mm wrench to unscrew the bolts securing the element to the car body. When the screws are unscrewed, begin to rotate the pump around its axis so that it does not cling to the car body with the mesh, that is, the filter itself. Now that your unit has been dismantled, it's time to start disassembling it. To do this, remove the clamps securing the pipe so that the hose is more elastic. Also be sure to disconnect the fuel system component's power plug. Then it will be necessary to remove the tube frame. We need to start at the base of the fuel cell. In order to pull the frame through the lower rubber clamp, you will need to make an effort. Please note that during this operation you must be careful not to tear the rubber retaining gasket. Having slightly bent the lower part of the frame, we remove it from the pump itself. Then, by removing the rubber retaining gasket, you get directly to the filter component. Remove it and replace it with a new one, reassembling all parts in the reverse order.

At this point, the replacement of the filter mesh can be considered complete. As you can see, there is nothing complicated about this - you just need to follow the steps indicated in the instructions.