How to open a car with a dead battery


It is possible to open a car with a dead battery in any of the closure options - with keyless entry, with the alarm on, or simply with the central locking activated. If the alarm system does not have an autonomous power supply, then in all of the above cases there is a single algorithm for how to open the door and get into the car interior when the battery is dead. But keep in mind that there are not only universal methods for opening a car if the battery is dead, but also their own characteristics for specific brands and models of cars. If you don’t know them, then read the article.

If the alarm system has an autonomous power source, then when the car doors are opened, the system will “scream”. However, using the methods given in the article, you can reduce the noise time to a minimum after starting the engine. Or turn off the alarm completely. Having listened to all the advice, opening the car if the battery is dead will not be difficult.

Technological options for solving the problem

First of all, you need to try to open the door lock with a key. If the cylinder is in good condition, the key turns easily. Drivers stop opening the door with a key as soon as the alarm is installed. The larva fails over time. The key cannot be turned. We have to solve the problem: how to open such a car if there is no power.

You can open the car in various ways. But there are two main options:

  • Power supply.
  • Opening the salon mechanically.

If you can open the hood, it will be possible to power the generator. Replace the battery or use a different battery. There are several ways to get into the salon:

  • Open the glass using a wire with a loop.
  • Open the car door.
  • Hook the hood cable.
  • Break the door glass with a heavy object (hammer or stone).
  • Drill out the door lock cylinder.

Ways to open a car if the battery is dead

In different cars, if the battery is dead, you can open the door in different ways. Their choice depends on the design and operation of the machine’s electrical circuits. Information on how to do this on the most popular machines is collected in the table.

AutoWhat is the best way to openWhy is thatWhat is needed for this
Lada Vesta
  • Through the radiator grille, connecting to the battery
  • Through the number plate illumination
  • The central locking system opens with a regular mechanical lock key
The grille is easy to remove, the battery is close, and the backlight is very easy to remove. Regardless of whether there is a standard or additional alarm, the central locking can be unlocked with a key (the lock is hidden behind a plug that needs to be pryed from below)
  • Power supply
  • Wires
  • Screwdriver
Lada Granta
  • Close the starter or generator
  • Through the turn signal
Plenty of space under the hood, crankcase protection can be easily removed. Just connect via turn signal
  • Wires with a cross-section of 5 mm² or more
  • Power supply
  • Screwdriver
Hyundai Solaris
  • Connect to the battery by opening the hood
  • Through a turn signal or license plate light
Weak mechanical protection of the hood, and the electrical system allows you to simply connect to its elements
  • Power supply
  • Wires
  • Screwdriver
Ford Focus
  • Feeding the battery by opening the hood
  • Apply power to the number plate illumination
At tricks, the grille bends and the hood opens, then you just have to light the battery
  • Power supply
  • Screwdriver
  • Lattice bending tool
  • Wires
Toyota Land Cruiser Prado
  • Connected to the starter, generator
  • Light the battery
  • Apply power to the number plate illumination
  • Connect the battery to the additional roof lighting (if equipped)
  • Use the diagnostic CAN bus to deactivate the alarm
The car is easy to “light up”, it is easy to remove the turn signal or backlight. Some models have overhead lighting. To deactivate the CAN bus you need special equipment
  • Power supply
  • Wires
  • Locksmith tools
  • Jack, clamp
Skoda Octavia
  • Power the source to the license plate light
  • Start the generator from another battery
The turn signal glass is difficult to remove, sometimes ECU errors may occur when connecting through the backlight, but by removing the protection you can connect from below to the power wires
  • Power supply
  • Wires
  • A set of keys
  • Jack
Volkswagen
  • Through the number plate illumination
  • Sign up for the fog lights (if they were turned on)
  • Starting the generator or starter
  • By opening the trunk with the key (if it is not locked by the central locking), many Volkswagen Passat have a socket in the trunk. You can power the battery through it
The easiest way is to power it through an outlet. If it is not there, through lighting. Through the generator and starter as a last resort.
  • Connecting wires
  • Screwdriver
  • External power supply
Kia Sportage
  • Side turn signal
  • Number plate illumination
  • Close/open the circuit between the battery and central locking
It's easier to start with a chain. Then the backlight and turn signal
  • Jack, clamp
  • Keys with screwdriver
  • Wires
  • Power supply
BMW X5
  • Start straight away with the generator or starter
  • You can try connecting through the backlight
  • Some cars have an emergency positive terminal on the bottom (its location depends on the car model)
The car has complex electronics, so it’s better not to mess with the electrical system
  • Jack, clamp
  • Wires for lighting
  • External power supply
  • Tools - wrenches, screwdriver
Mercedes
  • It’s better to try through the backlight and that’s it. Other methods may damage the car.
  • Closing the generator and starter will help, but this is difficult to do as it can damage the electronics!
  • Some cars have an emergency positive terminal in the area of ​​the front wheels in a plastic box
Most models have complex electronics and complex mechanical engine design (little space under the hood)
  • External power supply
  • Wires
  • Screwdriver

Power Delivery Technology

To power a dead battery, you need to have:

  • A special pillow.
  • Copper wires. You will need 2 meters, with a diameter of 2 mm.
  • Extra, well-charged battery.

The pillow is inserted into a thin gap between the hood of the car and its body. Then, using a bulb, air is pumped into the pillow. Wires are inserted into the enlarged slot. They are fixed on any positive terminal. The hood lid bends away from the side where the battery is located.

The free end is connected to an additional battery. Its minus is connected to the ground of the machine. A wheel nut or any unpainted surface will work for this. Special “crocodiles” secure the wires perfectly.

Good to know

To avoid such a problem in the future, it is recommended to configure access via the immobilizer. To do this, it is enough to connect a separate autonomous power supply system to the blocker. For example, you can use a lithium-ion battery. In this case, regardless of the power supply from the general electrical network, the immobilizer will still work. All that remains is to bring its blocking to the first place and synchronize the blocker with the supplied key. In this case, even if the battery is completely discharged, you will still have access to the car.

It is also worth remembering a few rules that will help you avoid such problems:

  • It is important to always monitor the battery charge level and condition. You shouldn’t wait every time until the corresponding symbol starts to light up on the car’s display, indicating that the battery is discharged.
  • It is necessary to promptly replace the old battery with a new one. If you decide to “reanimate” the old battery, you don’t need to get carried away with such procedures. In addition, it is important to remember that after the battery is restored, its life is significantly reduced.
  • After stopping the engine, you should always check that the radio and headlights are turned off. If they work for several days, this will inevitably lead to battery discharge.

How to power a generator

The above method may not always be used. The design of some cars does not allow the hood to be lifted slightly. You'll have to connect the generator. This procedure is much more complicated. To work you will need:

  • Jack.
  • Additional battery.
  • Copper wires - 2 meters, diameter 2 mm.
  • Spanners.

The front of the car is raised with a jack to a height that allows a person to carry out operations under the car. To organize safety, stands are placed under the car. The protection of the power unit is removed from below. It does not allow you to freely work with the generator.

One end of the copper wire is connected to the generator positive. The second one is fixed on the positive side of the additional battery. The negative is connected to the machine's ground in an accessible place. As soon as the power supply to the generator is restored, the door will open after pressing the key fob. All that remains is to charge the battery well.

You can organize meals in another way. However, it is much more complex. An in-depth knowledge of the vehicle's on-board electrical network is required. Similar methods are used by technicians working at service stations. They disassemble machine parts that block access to electrical wiring. Wires are connected in certain places to organize the supply of electricity.

How to open a salon when there is no power

There are various ways. For example, trying to insert a wire between the seal and the door glass. True, this is not always possible. In summer weather, when it is hot outside, sometimes there remains a small gap between the glass and the door frame. Some people deliberately leave such a gap to organize interior ventilation.

For this method you will need a soft wire. They push it inside, trying to grab the door handle. Of course, such manipulations require a certain skill. We'll have to try. To open the latch, you can make a loop from a thin rope. Try to put it on the clamp and pull it up. The door will open.

Is it possible to open the car with a dead battery?

A dead battery requires charging, and to do this you need to open the hood. Normally, this is done from the passenger compartment, but if access to the inside of the vehicle is impossible (for example, due to the lack of keys), then you will have to enter the engine compartment using other methods. One of the most common ways is through the removed left headlight and the removed radiator grille. However, there is no universal method; for each model it is necessary to select its own option for access to the engine compartment. Sometimes it is quite complex and time-consuming.

Once you have access to the battery, you can quickly recharge it, or borrow a battery from other car owners to open the car doors.

Among the available methods of opening a car, there are many exotic ones that can also harm the car. You need to resort to them after trying all the most popular methods. Alas, this does not always work out, especially if you need a car now, urgently.

So, let's move on to considering options for how to open a car door.

Mechanical door folding

This method is used only if it is impossible to slip a wire or rope. You'll have to open the door. The pad described above will be useful for this. If it is missing, a wooden wedge of a certain size is driven in.

The operation must be performed very carefully. To ensure that the paint coating remains undamaged, a rag is placed between the door frame and the body with a screwdriver. By bending the door slightly, it becomes possible to throw the wire around the handle and pull it hard. The door will open. If this is not possible, you can try to lift the clamp.

Extreme measures

Such methods are resorted to only in desperate situations. When you have tried everything possible, if all actions did not give a positive result. The easiest way is to take a heavy hammer and break the glass. Any heavy object will also work. Some cars are equipped with a small window. To cause minimal damage, it is better to break it.

Sometimes they resort to a more barbaric method. They just drill out the door lock. The door will, of course, open, but the consequences will be too expensive. All the locks will have to be changed.

There is an original option when a special “blank” key is used. Its design makes it possible to crash into the door cylinder. By pressing on it, you can turn the key and the door will immediately open. Unfortunately, after such a mechanical impact, it is impossible to do without repairs. To never encounter such problems, always monitor the condition of your battery. Do not allow it to become completely discharged. Only then will you never have to open the car using the methods described above.

Rating
( 1 rating, average 5 out of 5 )
Did you like the article? Share with friends:
For any suggestions regarding the site: [email protected]
Для любых предложений по сайту: [email protected]